Timber Floating Shelves

Step 1 – Sourcing the Wood

I managed to pick up a few bits of reclaimed wood from a reclaim yard for a couple of pounds – this got me a couple of crates and some timber. I like the worn, rustic look so anything with old nail holes, rust etc. is a plus.
For my shelves I used these boards and found a couple of pieces of beat up timber to use as the support for the shelf.


Step 2 – Cleaning it up 

I liked the rust and damage to these boards so didn’t want to sand them and take that away. Instead I opted for wet steel wool which got all the dirt off and then kind of blended some of that back into the wood to keep it looking weathered. Nails were removed.
I had to glue and clamp all the boards in places as they were split in quite a few places (2 of these boards I deemed too far gone to be used as practical shelves, so will save them for something else).

FullSizeRender 4.jpg

Step 3 – Stain

I ended up going with a Finishing Oil to enhance colour. I went light and used dry steel wool in between two coats to ensure a good bond. I finished off with a one coat of Clear Coat to protect the wood.

Left Board finished


Step 4 – Creating the Shelf

My design was to have a Board sit on a piece of 2×4 Timber which would sit on floating brackets. To secure the Board to the timber I made 4 metal brackets that attached to the back of the board and timber to help keep them together. I also added some Gripfill in between for added bond. As the boards weren’t 100% level I felt I needed to add the brackets to ensure they fixed together well.
I also drilled 3 x 12mm holes into the Timber – this would allow the shelve supports to hold up the shelf when on the wall.



Step 5 – Fixing the Shelf

I wanted 3 floating brackets to support this so drilled holes for these evenly on the back of the supporting timber. I then measured these out on the wall I was fixing to and secured.
As my house is fairly new (<20 years) so a lot of my walls are ‘dry-lined’ – which is a pain when trying to fix/hang anything substantial off them. I use and recommend ‘Gripit’ fixings – they have 4/5 different sizes which require what can seem a big drill hole to support but I have found these excellent when fixing to plasterboard.

Initial hole for Gripit Fixings
Fixings are pushed in and tightened to secure
Floating shelf brackets screwed to the Gripit fixings

Finished Floating Shelf

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s